Troubleshooting; Error Messages - Animo OptiFresh Bean User Manual

6

Troubleshooting

6.1

Error messages

Problem
E1 Level error
E2 Level error
E3 Level error
E4 Brewer error
E5 Brewer error
E6 Boiler temp
E7 BM error
E8 Mixer 2 error
E9 Mixer 3 error
E10 Valve error
EN
Possible cause
Sensor level problem.
Boiler is filling up too slowly.
There is no water pressure or the
water tank is empty.
Boiler is not filling up.
Brewer has not started from its ini-
tial position.
Brewer has not returned to its initial
position.
Temperature sensor problem.
Brewer motor overload/stuck.
The brewer is stuck or fitted incor-
rectly.
Mixer 2 overload/stuck.
Mixer 2 is unclean or incorrectly fit-
ted.
The control switched off the outlets.
Mixer 3 overload/stuck.
Mixer 3 is unclean or incorrectly fit-
ted.
The control switched off the outlets.
Valve or ventilator overload/stuck.
Valve or ventilator outlet overload.
The control switched off the outlet.
85
OptiFresh Bean
Correction
Contact the dealer or service
engineer.
Check the water pressure. Turn
the water supply tap completely
open. Check the connection tube
for any kinks. Switch the machine
off and on again.
Check the water pressure. Turn
the water supply tap completely
open. Check the connection tube
for any kinks. Switch the machine
off and on again.
Check whether the brewer is cor-
rectly placed into its bracket.
Switch the machine off and on.
Check the brewer.
Switch the machine off and on.
Contact the dealer or service
engineer.
Remove the brewer from the
machine, clean and install the
brewer correctly. Switch the
machine off and on again.
Remove the mixer from the
machine, clean and install the
mixer correctly.
Check whether the rotor can run
freely.
Switch the machine off and on
again.
Remove the mixer from the
machine, clean and install the
mixer correctly.
Check whether the rotor can run
freely.
Switch the machine off and on
again.
Contact the dealer or service
engineer.
2015/02 Rev. 1.0