Mitsubishi Electric FR-F500 Series Instruction Manual page 28

( 5 ) Connecting the control circuit to a power supply separately from the main circuit
If the magnetic contactor (MC) in the inverter power supply is opened when the protective circuit is operated,
the inverter control circuit power is lost and the alarm output signal cannot be kept on. To keep the alarm
signal on terminals R1 and S1 are available. In this case, connect the power supply terminals R1 and S1 〈L
〉 of the control circuit to the primary side of the MC.
and L
21
• • • • Model FR-F520-0.75K to 3.7K, FR-F540-0.75K to 3.7K
<Connection procedure>
R1 〈L
• • • • Model FR-F520-5.5K to 55K, FR-F540-5.5K to 55K
<Connection procedure>
R1
〈L
11
R S T
〈L 〉
〈L 〉 〈L 〉
3
1 2
MC
Main power supply
Note: 1. When the main circuit power (R, S, T) 〈L
(terminals R1, S1 〈L
2. When using a separate power supply, the jumpers across R-R1 and S-S1 〈L
must be removed. Otherwise the inverter may be damaged.
3. For a different power supply system, which takes the power of the control circuit from other than
the primary side of the MC, the voltage should be equal to the main circuit voltage.
4. For the FR-F520-5.5K to 55K, FR-F540-5.5K to 55K, the power supply cables must not be
connected to the lower terminals. If connected, the inverter may be damaged.
5. Supplying power to only terminals R1 〈L
an error display (E.OC1).
R
〉 S
〈L
1 T
〈L 〉
2
〈L 〉
3
Terminal block for main circuit
S1 〈L 〉
21
〉
11
S1
〉 〈L 〉
21
Power supply terminal
block for control circuit
〉). Otherwise the inverter may be damaged.
, L
11 21
INSTALLATION AND WIRING
1) Loosen the upper screws
2) Remove the lower screws.
3) Remove the jumpers.
4) Connect the separate power supply cables for control circuit to the
lower terminals (R1, S1 〈L
11
Power supply terminal
block for control circuit
1) Loosen the upper screws.
2) Remove the lower screws.
3) Pull out and remove the jumper.
4) Connect the separate power supply
cables for control circuit to the
upper terminals (R1, S1 〈L
〉 is on, do not switch off the control power
L , L
1 2 3
〉 and S1 〈L 〉 and entering the start signal will result in
11 21
17
〉).
, L
21
〉). (Note 4)
, L
11 21
-L and L
1 11
11
〉
-L
2 21