Periodic Inspection - TOHATSU MD 30B2 Owner's Manual

ENOM00708-0

2. Periodic inspection

It is important to inspect and maintain your outboard motor regularly. At each interval on
the chart below, be sure to perform the indicated servicing. Maintenance intervals should
be determined according to the number of hours or number of months, whichever comes
first.
For periodic inspection and maintenance, consult your servicing dealer.
Description
Fuel filter
High pressure fuel
*1
filter
Piping/Hoses
Fuel tank
Fuel tank cap
Fuel System/
Compres-
sion System
*1
Fuel pump
*1
Air filter
*1
Drive belt
*1
Fuel Pressure
*1
Air Pressure
Ignition Spark plug
*1
Starter motor
Starting Sys-
tem
Battery
Oil tank
Engine oil
Oil pipe
system
Oil filter
Propeller
Gear oil
Lower Unit
*1
Water pump
*1
Thermostat
*1
Power trim & tilt
*1
Warning system
Bolts and Nuts
Inspection intervals
First 20 Every 50 Every 100 Every 200
hours of 1 hours of 3 hours of 6 hours of 1
month months months year
Replace
Replace
Replace
Replace Replace Replace
INSPECTION AND MAINTENANCE
Inspection procedure
Check and clean or Replace if neces-
sary.
Replace every 200 hrs or 2 years
Check and clean or Replace if neces-
sary
Clean
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check and Replace if necessary.
Check and replace defective parts if
necessary.
Check and replace defective parts if
necessary.
Remove carbon deposits or Replace if
necessary.
Check for salt deposits and the battery
cable condition.
Check installation, fluid quantity, gravity.
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check for bent blades, damage, wear.
Change or replenish-oil and check for
water leaks.
Check for wear or damage.
Check and Replace if necessary.
Check & replenish oil, manually operate
Check function
Retighten
75
Remarks
Entire cartridge
Including filter
0.8–0.9 mm
(0.031–0.035 in)
10
Replace impeller
every 12 months.