Forward, Reverse, And Acceleration - TOHATSU MD 30B2 Owner's Manual

1
1. Idle port
2. Cooling water check port 75, 90, 115
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 min
(rpm) for several minutes.
Clutch in (In gear)
-1
800 min (rpm)
ENOM00 -0
Trolling engine speed control
function
If the main switch key is pressed for 1 (one)
second during idling or trolling operation,
engine revolution change.
ON
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
Starting
-1
700min (rpm) 800min
-1
800min (rpm) 900min
2
ENOF00665-0
-1
Clutch off (Out of gear)
-1
800 min (rpm)
1
seconds
ENOF00876-0
-1
(rpm)
-1
(rpm)
ENGINE OPERATION
ENOM00046-A
5. Forward, reverse, and
acceleration
ENOW00037-0
WARNING
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
WARNING
Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
Arrange the tether so that will not be
caught by any object when pulled.
Be careful not to pull the tether acciden-
tally during cruising. Unintentional stop
of engine can cause loss of control of
outboard motor. Rapid loss of engine
power can lead to falling down or caus-
ing passenger(s) to be thrown over-
board.
ENOW00042-0
WARNING
Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/or
hull may be damaged.
Do not shift into Reverse during cruis-
ing, or control may be lost, falling down
or causing passenger(s) to be thrown
overboard. Leading to serious personal
injury, and steering system and/or shift-
ing mechanism may be damaged.
51
7