TOHATSU MD 30B2 Owner's Manual page 74

72
INSPECTION AND MAINTENANCE
ENOM00085-C
Flushing attachment (bottom cowl)
*75, 90, 115
ENOW00921-0
Do not operate the engine when flushing
the outboard motor with a flushing attach-
ment as this can cause damage to the out-
board motor.
ENOW00922-0
To prevent the engine from starting when
you are near the propeller, remove the stop
switch lock.
1. Tilt down the outboard motor.
2. Remove the flushing connector cap
from the outboard motor, and screw in
the flushing attachment.
3. Attach the flushing attachment and
connect a water hose. Turn on the
water and adjust the flow.
Continue flushing the outboard motor
for 3 to 5 minutes
4. After the flushing, be sure to reattach
the flushing connector cap.
10
5. Tilt up the outboard motor.
75, 90, 115
1. Flushing attachment
CAUTION
CAUTION
1
ENOF01326-0
ENOM00085-A
Flushing by test tank
ENOW00081-0
WARNING
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors
or in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be
fatal if inhaled for any length of time.
ENOW00036-A
CAUTION
When the engine is started in the test tank,
to avoid over heating and water pump
damage, be sure the water level is at least
10 cm (4 in.) above the anti ventilation
plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 79)
Run the engine only at idling.
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
1
ENOF00863-0