TOHATSU MD 30B2 Owner's Manual page 57

Side mount RC type
1. Put the control lever in the Neutral
position and run the engine for 2-3
minutes at idling speed for cooling
down if it has been running at full
speed.
N
1
2. Turn the main switch key to the OFF
position or push the stop switch. ( Do
not forget to turn the key off).
OFF
1. Control lever
2. Main switch key
ENOW00869-0
WARNING
After stopping the engine:
Close the air vent screw on the fuel tank
cap.
Disconnect the fuel connector of the
engine and the fuel tank.
Disconnect the battery cord, after each
use.
2
ENOF00881-0
ON
START
2
ENOF00882-0
ENGINE OPERATION
Emergency engine stopping
Remove stop switch lock to stop the
engine.
N
R
1
2
1. Stop switch
2. Stop switch lock
2
1. Stop switch
2. Stop switch lock
ENOM00910-0
Spare emergency stop switch lock
A spare emergency stop switch lock is
provided in the tool bag.
When used as described, the emergency
stop switch clip and emergency stop
switch lanyard system stops the engine if
the operator falls away from the controls.
When an operator falls into water, be sure
to use emergency stop switch lock of the
spare.
Be sure to confirm the spare stop switch
55
F
ENOF00883-0
1
ENOF00884-0
7