TOHATSU MD 30B2 Owner's Manual page 49

2. Insert the main switch key.
3. Set the control lever in the Neutral
position.
N
1
R
1. Shift lever
4. Set the throttle grip to START position.
1
1. Throttle grip
ENON00613-A
Note
Turn the throttle grip to the "START" (fully
closed), before turning the main switch key
to "ON".
The wrong operation i.e. turn the main
switch key to "ON" on the condition that the
handle grip or accel lever is opened will be
memorized by ECU (engine control unit).
If this wrong operation has done repeatedly,
it will have a possibility that the three warn-
ing lamps flash. In this case, turn the throttle
grip to "START" (fully closed) and start the
F
ENOF00865-0
ENOF00866-0
ENGINE OPERATION
next operation after returning the main
switch key to "OFF".
5. Turn the main switch key to ON posi-
tion and confirm three warning lamps
light up with buzzer sound and then go
off.
6. Turn the main switch key to START
position and release the key when the
engine has started. The key returns to
the original position, automatically.
N
R
1
OFF
ON
START
PUSH TO IDL CHAN
1. Main switch key
2. Warning lamp
ENOW00032-0
CAUTION
Do not keep turning starter motor for over
5 seconds, or the battery may be con-
sumed, potentially making the engine start-
i n g i m p o s s i b l e a n d / o r d a m a g i n g t h e
starter.
If cranking over 5 seconds fails to start
engine, return main switch to "ON", and
crank engine again after 10 seconds or
more.
7. Check the cooling water from cooling
water check port.
47
F
7
2
ENOF00867-0