ENOW00085-0
WARNING
Do not hold propeller with hand(s) when
loosening or tightening propeller nut. Put a
piece of wood block between propeller
blade and anti-ventilation plate to hold pro-
peller.
ENOW00086-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
Propeller must be selected that will allow
the engine to reach recommended rpm
when cruising at wide-open throttle.
Wide-open throttle rpm range
30/40 : 4750 – 5750 min
50 : 5150 – 5850 min
75/90 : :5150 – 5850 min
115 : 5150 – 5850 min
Genuine propellers are listed on PROPEL-
LER TABLE of this manual (See page 85).
1. Remove the split pin, propeller nut and
2. Remove the propeller and thrust
3. Apply water proof grease to the pro-
4. Install the thrust holder, propeller,
30, 40, 50
ENOF00084-B
1. Propeller
2. Thrust holder
3. Stopper
4. Washer
5. Propeller nut
6. Split pin
75, 90
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
1. Propeller
2. Thrust holder
3. Bush
4. Adaptor
5. Washer
6. Propeller nut
washer.
holder.
peller shaft before installing a new pro-
peller.
stopper, washer and propeller nut onto
the shaft.
2
2
33
INSTALLATION
6
3
5
4
1
ENOF01315-0
7
6
5
4
3
1
ENOF01335-0
5