TOHATSU MD 30B2 Owner's Manual page 91

1. Disconnect the fuel hose from the out-
board motor.
2. Remove the top cowl.
3. Release the drain tube from the clamp
and pull the tube outside the bottom
cowl. Place an approved fuel container
under the drain tube end and use a
funnel to avoid spilling fuel.
4. Loosen the vapor separator drain
screw.
5. Tilt up the outboard motor until fuel
flows out of the drain tube.
6. Leave the outboard motor in this posi-
tion until all fuel has been drained.
7. When thoroughly drained, retighten the
drain screw securely.
8. Check the drained fuel for the pres-
ence of water or other contaminants. If
either is present, reassemble the out-
board motor, refill the vapor separator
with fuel, and then drain the fuel again.
Repeat this procedure until no water or
other contaminants are present in the
drained fuel.
30, 40, 50
1
*Remive fuel filter beforedraining
1. Vapor separator draine screw
75, 90, 115
1. Vapor separator draine screw
ENOM00102-0
Battery
ENOW00931-A
Place the battery away from any source
of fire, sparks and open flames such as
burners or welding equipment.
Place the battery away from fuel tank.
Accidental sparks of battery may cause
explosion of gasoline.
1. Disconnect the battery cables and be
sure to remove the negative terminal
first.
2. Wipe off any chemical deposits, dirt, or
grease.
3. Apply grease to the battery terminals.
4. Charge the battery completely before
storing it for the winter.
5. Recharge the battery once a month to
prevent it from discharging and the
electrolyte from deteriorating.
6. Store the battery in a dry place.
ENOF01342-0
INSPECTION AND MAINTENANCE
1
WARNING
89
ENOF01343-0
10