Remote Control Procedures - Emerson VOLTA CF590BQ00 Owner's Manual

BP7513 Volta CF590 1/5/16
10.1
Your Emerson Ceiling Fan/Light Remote Control
consists of hand-held transmitter and a receiver which
is mounted under the fan ceiling cover. The remote
control is designed to separately control your ceiling fan
speed and light intensity.
The remote control transmitter is powered by two AAA
alkaline batteries (included). To prevent possible
damage if the batteries should leak, be sure to remove
the batteries when the control is not to be used for an
extended period of time.
Code switches in the transmitter and receiver may be
set in 32 different positions. If your fan and light go on
and off without using your control, you may be getting
10.3
Installation of Batteries: Remove the battery cover by
pressing firmly below the arrow and sliding the cover off
the control (Figure 48).
Install two AAA alkaline batteries and reinstall the
battery cover (Figure 48).
10.4
Installation of Storage Bracket for Remote Control:
A storage bracket is provided for holding your remote
control when not in use. If you desire to use the
bracket, install it on a wall that is away from excess
heat or humidity (Figure 49).
10:52 AM Page 24

10. Remote Control Procedures

interference from other remote units such as garage
door openers, car alarms or security systems. To
remedy this situations, simply change the combination
code in your transmitter and receiver.
10.2
Preset Memory Feature: Your Emerson receiver is
equipped with a preset memory feature. If the AC
supply to the receiver is powered through a wall switch,
when the switch is turned OFF, the control will
remember the light intensity and fan speed. When the
switch is turned back ON the light and fan will resume
operation as they were prior to the switch being turned
OFF.
TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 48
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 49
24
REMOTE CONTROL
LEVERS
1 2 3 4 5
CODE
SWITCHES
REMOTE CONTROL
TO INSTALL BRACKET TO
WALL:
SLIDE THE COVER UP TO
EXPOSE THE SCREW
HOLES FOR INSTALLATION
U.L. Model No.: CF590