Table of Contents
Advertisement
5. How to Wire Your Ceiling Fan
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
3. Screw the two threaded studs (supplied) into the
tapped holes in the hanger bracket.
4. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 12).
5. Secure the ceiling cover in place by sliding
lockwashers over the threaded studs and installing
the two knurled knobs (supplied). (Figure 12).
Tighten the knurled knobs securely until the ceiling
cover fits snugly against the ceiling and the hole in
the ceiling cover is clear of the downrod. Your fan is
now wired to be turned on and off from the fan
switch.
Your Emerson Ceiling Fan/Light SR600 Remote Control
consists of hand-held transmitter and a receiver which is
mounted under the fan ceiling cover. The remote control
is designed to separately control your ceiling fan speed,
airflow direction and light intensity.
The remote control transmitter is powered by two AAA
alkaline batteries (included). To prevent possible
damage if the batteries should leak, be sure to remove
the batteries when the control is not to be used for an
extended period of time.
Code switches in the transmitter and receiver may be
set in 32 different positions. If your fan and light go on
and off without using your control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems. To
remedy this situations, simply change the combination
code in your transmitter and follow procedures for
Setting Operating Frequency of Remote Control.
Preset Memory Feature
Your Emerson receiver is equipped with a preset
memory feature. If the AC supply to the receiver is
powered through a wall switch, when the switch is
turned OFF, the control will remember the light intensity
and fan speed. When the switch is turned back ON the
light and fan will resume operation as they were prior to
the switch being turned OFF.
6. Remote Control Procedures
(continued)
Figure 12
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
Installation of Battery
1. Remove the battery cover by pressing firmly below
the arrow and sliding the cover off the control
(Figure 13).
2. Install two AAA alkaline batteries and reinstall the
battery cover.
TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 13
Please contact 1-800-654-3545 for further assistance
9
CEILING
COVER
THREADED
STUDS (2)
LOCKWASHERS
(2)
KNURLED
KNOBS (2)
WARNING
REMOTE
CONTROL
LEVERS
ON
1
2
3
4 5
I
CODE
SWITCHES
SR600 REMOTE CONTROL
emersonfans.com
ETL Model No.: CF921
Advertisement
Table of Contents
