Table of Contents
Advertisement
8.1: Preset Memory Feature
Your Emerson Receiver is equipped with a preset memory
feature. If the AC supply to the Receiver is powered
through a Wall Switch, when the Switch is turned OFF, the
control will remember the light intensity and fan speed.
8.2: Installation of Batteries
The Remote Control Transmitter is powered by two AAA
Alkaline Batteries (not included).
To prevent possible battery leakage damage, be sure to
remove the Batteries when the Control is not to be used
for an extended period of time.
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Remote Control.
Install two new AAA Alkaline Batteries into the Battery
Compartment following the correct battery placement
printed on the compartment (Figure 32).
NOTE: Never use old and new batteries together in
unit.
Replace the Battery Compartment Cover by sliding the
Cover back onto the Remote Control.
8.3: Setting Operating Frequency
of Remote Control
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Control
(Figure 33).
Your Remote Control has code switches which must be
set in one of 32 possible code combinations.
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position. Change
the switch settings as follows:
Slide the five switch levers in the Remote Control to your
choice of ON (up) or down positions. Use a ball-point pen
or small screwdriver and slide the levers firmly up or down
(Figure 33).
The sixth switch marked ON and I is for dimming control of
lights: Set switch to ON to allow for dimming of the lights.
Set switch to I for no dimming of the lights such as for
fluorescent bulbs.
NOTE: If your fan and light go on and off without
using your control, you may be getting interference
from other remote units such as garage door openers,
car alarms or security systems.
8. Remote Control Procedures
When the Switch is turned back ON the light and fan will
resume operation as they we re prior to the switch being
turned OFF.
TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 32
BATTERY
COMPARTMENT
COVER
Figure 33
To remedy this situations, simply change the combination
code in your remote control transmitter.
20
REMOTE CONTROL
REMOTE CONTROL
LEVERS
ON
1
2
3
4 5
I
CODE
SWITCHES
REMOTE CONTROL
U.L. Model No.: CF411
Advertisement
Table of Contents
