Ip Address-Alloc Bootp; Reset - TP-Link TL-SG3210 Cli Reference Manual

Example
Enable the DHCP Client function when the management VLAN of the switch is
VLAN1:
TL-SG3424(config)# interface vlan 1
TL-SG3424(config-if)# ip address-alloc dhcp

ip address-alloc bootp

Description
The ip address-alloc bootp command is used to enable the BOOTP Protocol.
When the BOOTP Protocol is enabled, the switch will try to obtain IP address
from BOOTP Server. This command should be configured in the Interface
Configuration Mode of the management VLAN.
Syntax
ip address-alloc bootp
Command Mode
Interface Configuration Mode (interface vlan)
Example
Enable the BOOTP Protocol to obtain IP address from BOOTP Server when the
management VLAN of the switch is VLAN1:
TL-SG3424(config)# interface vlan 1
TL-SG3424(config-if)# ip address-alloc bootp

reset

Description
The reset command is used to reset the switch's software. After resetting, all
configuration of the switch will restore to the factory defaults and your current
settings will be lost.
Syntax
reset
Command Mode
Privileged EXEC Mode
122