Programming The Virtual Extension Cards And Ip Telephones; Assigning Ip Addressing Information - Panasonic KX-NS1000 Getting Started

4.3.1 Assigning IP Addressing Information

4.3 Programming the Virtual Extension Cards and IP
Telephones
4.3.1 Assigning IP Addressing Information
The IP address of an IP telephone, the subnet mask address, the default gateway address, and the PBX's IP
address must be assigned to the IP telephone before it can be used on the network. These IP addressing
information can be assigned in the following ways;
For IP-PTs
•
Using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-PT is on the
same LAN as the PBX
The DHCP server automatically assigns the IP address of the IP-PT, the subnet mask address, and the
default gateway address to the IP-PT.
The PBX's IP address can also be assigned automatically to the IP-PT in the process of being registered
to the PBX. For details about registering the IP-PT, refer to "4.3.2 Registering IP Telephones".
Note
For information about the DHCP Server feature, refer to "7.1.2 DHCP (Dynamic Host Configuration
Protocol) Server" in the Installation Manual.
•
Using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-PT is on a
remote office LAN
While the DHCP server automatically assigns the IP address of the IP-PT, the subnet mask address, and
the default gateway address to the IP-PT, the PBX's IP address must be assigned manually.
Follow the procedure below to assign the PBX's IP address.
Note
•
By assigning the PBX's IP address to one IP-PT, it is possible to assign the PBX's IP address to
other IP-PTs or IP Cell Station Units (IP-CSs) on the same LAN through system programming. For
details, refer to "9.14 PBX Configuration—Configuration—Slot—V-IPEXT32—Port Property—
Option—
•
IP-PTs can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when IP-PTs are located on several LANs, a DHCP server is required on each LAN.
•
Since the default setting of the DHCP client function is enabled for IP-PTs, simply connect the
IP-PTs to the LAN to use the DHCP server.
36 Getting Started
ANNOUNCE Mode" in the PC Programming Manual.