Panasonic KX-NS1000 Getting Started page 50

4.3.2 Registering IP Telephones
For KX-UT Series SIP Phones
If networking settings have been completed, when KX-UT series SIP phones are connected to the same
network as the PBX, they will be registered automatically as same as when they are registered in Full Automatic
mode. No registration procedure is required.
Note
No more than 64 IP-PTs can register extension numbers at the same time.
Manual Mode
For IP-PTs or KX-UT Series SIP Phones
After connecting IP-PTs or KX-UT series SIP phones to the PBX over a network, register those IP terminals
to the PBX manually.
Follow the procedure below for registration.
To register the IP-PT or KX-UT series SIP phone by entering the MAC address directly:
50 Getting Started
1. a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b.
For IP-PTs:
Click Virtual ® V-IPEXT32.
For KX-UT series SIP phones:
Click Virtual ® V-UTEXT32.
c.
For IP-PTs:
Move the mouse pointer over the V-IPEXT32 card
(Virtual 32-Channel VoIP Extension Card).
For KX-UT series SIP phones:
Move the mouse pointer over the V-UTEXT32 card
(Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.
2. If the Connection column for the port is INS, click INS,
and then click OUS on the dialogue box to change the
port's status.
3. Enter the MAC address of the IP-PT or SIP phone in the
IP Phone Registration ID (MAC Address) box.
4. Click Apply.
Once the IP-PT or SIP phone is successfully registered,
its status will update to show "Registered".
5. In the Connection column for the port, click OUS, and
then click INS on the dialogue box to change the port's
status.
6. For KX-UT series SIP phones only:
Follow the procedure below to change the IP Terminal
Registration Mode from Manual to Full Automatic.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot ® Site Property ® Main.
b.
In the Main tab, select Full Automatic for IP
Terminal Registration Mode.
c.
Click OK.