Maintenance; Print Pad Maintenance - 3D Systems Cube 3rd Generation Quick Start Manual

MAINTENANCE

PRINT PAD MAINTENANCE

Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad.
These procedures can also be affected by a print pad that is too shiny. Remove all glue and print
material from the print pad before performing Print Pad Maintenance.
PLATE
1. Select
2. Remove the print pad. Lift up the front of the print pad and
pull it out of the printer.
NOTE: The print pad is magnetically attached to
the adjustment knobs.
3. Using the included fine-grit sandpaper, lightly buff the print
pad.
NOTE: Refer to the section titled Clean The Print
Pad for specific instructions.
NOTE: Ensure the print pad is clean and dry
before installing it in the printer.
4. Select the checkmark
5. Perform the Auto Level and Auto Gap procedures.
MAINTENANCE.
to continue.
26