3D Systems Cube 3rd Generation Quick Start Manual page 24

NOTE: If the color built into the test print does
not match a color of one of the installed print
cartridges, the printer will assign an installed
cartridge color to the test print. Select the
checkmark
26. Gently squeeze the bottle and apply two thin layers of
Cube Glue to the print pad. Select the
continue.
NOTE: Apply enough glue to cover a square area
of 5" (15 cm).
NOTE: For best results, apply two thin layers of
Cube Glue using slow, circular motions.
NOTE: Allow the glue to dry before printing.
NOTE: The print jets will begin to heat and then
begin printing the welcome message test print.
to continue.
checkmark to
21