3D Systems Cube 3rd Generation Quick Start Manual page 23

NOTE: If Auto Gap is not successful, it is
recommended that you perform Auto Level and
Auto Gap again. Select
NOTE: If Auto Gap is not successful the second
time, select
information, refer to the section titled PRINT PAD
MAINTENANCE. Once the PLATE MAINTENANCE
procedure has been performed, perform Auto
Level and Auto Gap.
NOTE: If Auto Gap is still not successful, select
MANUAL GAP
section titled Manual Gap Adjustment for more
information. Once the Manual Gap Adjustment
has been performed, note the final reading for
future reference.
25. Select PRINT.
AUTO LEVEL
PLATE MAINTENANCE. For more
ADJUSTMENT. Refer to the
to continue.
20