Recover A Cartridge - 3D Systems Cube 3rd Generation Quick Start Manual

RECOVER A CARTRIDGE

PURGE JETS
Use the
and need to recover it, contact Cubify Support.
The cartridge must be properly installed in the printer before performing the procedure. Refer to the user
guide for more information.
1. Carefully open the cartridge door and remove it from the
cartridge.
2. Select SETUP
3. Navigate to the
4. On the touchscreen, select the print jet you would like to purge. Select the
continue.
5. Using the pliers from the tool kit, carefully pull down the material sleeve.
Caution: Do not pinch or twist the material sleeve.
6. Using the pliers, grasp the print material just above the
sleeve and push the material upward.
NOTE: The upward pressure will allow the
feeder to engage the print material.
7. Continue to push the print material upward until the print jet begins purging.
utility to recover a print cartridge. If you do not have the door on your cartridge
on the touchscreen.
PRINT JET CALIBRATION screen and select PURGE
31
JETS.
checkmark to