Forward Speed Too Low; No Reverse Motion; Loss Of Hydraulic Oil - Wacker Neuson DPU 7060SC Operator's Manual

Faults
8.3

Forward speed too low

8.4

No reverse motion

8.5

Loss of hydraulic oil

T01052GB
The machine can be started, but does not move – LED ring (b) blinks
rapidly
Cause
The operator is standing in the
machine's safety zone.
Cause
To little hydraulic oil in the centre pole
head.
Air in hydraulic control.
Cause
Mechanical fault.
Cause
Leaks, hydraulic hose defective.
Contact the Wacker Service in case of additional failures.
Remedy
Operator must leave the safety zone.
Remedy
Top up hydraulic oil.
Bleed system.
Remedy
Contact Wacker service dept.
Remedy
Change defective parts.
Note: Bleed system after every
dismantling operation.
32