Faults; Forward Speed Too Low; Reverse Speed Too Low; No Reverse Motion - Wacker Neuson DPU 6055 Operator's Manual

Forward speed too low

Reverse speed too low

No reverse motion

Loss of hydraulic oil

The charge control lamp will not extinguish and/or the buzzer will not stop buzzing

Engine does not start

T00785GB
Cause: - To little hydraulic oil in the centre pole head.
- Air in hydraulic control.
Remedy: - Top up hydraulic oil.
- Bleed system.
Cause: - Too much oil in centre pole head.
Remedy: - Correct oil level in accordance with mark.
Cause: - Mechanical fault.
Remedy: - Contact Wacker service dept.
Cause: - Leaks, hydraulic hose defective.
Remedy: - Change defective parts.
Note: Bleed system after every dismantling operation.
Cause: - Dynamo defective.
- Control unit defective.
Remedy: - Contact Wacker service dept.
- Replace control unit (on rear of the dynamo).
Cause: - Ignition lock defective.
- Starter defective.
- Start knop defective.
- Battery flat.
- Lack of lubricating oil.
Remedy: - Change defective parts.
- Charge battery.
- Fill up with oil and actuate valve lever at oil filter housing once.
33

FAULTS