Oce TDS600 User Manual page 95

Make all required settings.
2
Insert the original face down, right aligned with the original guide on the
3
original feed table.
Right hand side
(left hand side in the feed direction, face-down) by selecting a specific roll or
sheet feeder. If the paper width of the original is larger than the paper width of
the selected roll or sheet feeder, the remaining paper part on the right hand side
will not be scanned (see figure 57).
[57] Example of removing the right hand side of an original
Copying with removed filing strip along the right hand side
Select the required media in the 'Custom' section on the operating panel.
1
Select the 100% value for the 'Zoom' function.
2
Make other settings as required.
3
Feed the original.
4
Leading and trailing edge
leading and trailing edge to eliminate or add a filing strip. Leading and trailing
edges can be extended up to 400 millimetres (mm) or shortened up to 100 mm
(see figure 58).
Special copy and scan jobs
You can also remove the filing strip along the right hand side
Face up:
Right hand side
- 40 mm
It is also possible to adjust the length of both the
Face down:
left hand side in feed
direction
95