Belt Unit - Oce TDS600 User Manual

The optional reinforcement unit supports all media sizes larger than A4.
However, A4 size media can also be reinforced if you enable A4 reinforcement
in the Settings Editor.
Reinforcement is only possible with the Standard folding method.
Note:
See 'Reinforcement unit' on page 296 for more information about inserting a
new tape roll and other maintenance issues.
Enable reinforcement
Click on the 'Jobs' button in the Settings editor.
1
Select the 'Copy' tab if you want to enable folding reinforcement for copy jobs
2
or select the 'Print' tab if you want to enable folding reinforcement for print
jobs.
Open the 'Defaults' folder.
3
Open the 'Finishing' folder.
4
Select the 'Folding reinforcement' option.
5
Enable folding reinforcement in the right part of the window.
6
Click on the 'Apply' button to save any changes you have made.
7

Belt unit

A belt unit offers a large capacity and more flexibility. On the belt unit up to
100 A0 prints can be delivered offset stacked. You can adjust the side guides
of the belt, depending on the width of the folded package.
See 'Océ Power Logic: Account logging' on page 225 for more information
about selecting the belt for default print/copy/off line delivery.
The belt unit can also be selected from the drivers (including Plot
Note:
Director) or the copier operating panel. The remote command overrules the
key operator setting.
Selecting belt as folded copy delivery on copier operating panel
Open the 'Finishing' card in the 'Copy' section of the copier operating panel.
1
Press the 'Folding' function button to select full folding.
2
Press the 'Folded copy delivery' function button to select the belt.
3
Adjusting the side guides of the belt
Loosen the nuts (see figure 201).
1
The folder 297