Cut Sheet Material - Oce TDS600 User Manual

Cut sheet material

When a sheet feeder is empty during a print job, a 'Sheet feeder x empty'
message is displayed at the printer operating panel and in the System Control
Panel (SCP) application. You then have to load new cut sheet print material.
You must fan polyester cut sheet before use to prevent sticking together.
Note:
Also avoid the use of sheets that have already been printed on one side.
Load cut sheet material
Open the appropriate drawer (see figure 133).
1
[133] Opening the appropriate drawer
Release the right hand guide by squeezing the light green release handle on the
2
guide (see figure 134) and move the guide to the required media size indicator.
Make certain that the handle is properly aligned with the appropriate
Note:
indicator.
246 Océ TDS600 Multifunctional Digital System User Manual