Oce TDS600 User Manual page 291

Set folding legend
Press the 'Feeding' card in the 'Original' section.
1
Press the function button 'Legend location'.
2
Select 'Leading' or 'Trailing'.
3
In the drivers, this setting is called the 'Folding orientation', with the
options 'Portrait', 'Landscape' and 'Automatic'.
Set the drawing method
Press the 'Feeding' card in the 'Original' section.
1
Press the function button 'Drawing method'.
2
Select 'Standard', 'Ericsson' or 'Afnor'.
3
Set the folded package width
Press the 'Finishing' card in the 'Print' section.
1
Press the function button 'Folded package'.
2
Select 'Width'.
3
Enter a range between 186 - 230 mm in steps of 1 mm; default 210 mm.
Set the folded package length)
Press the 'Finishing' card in the 'Print' section.
1
Press the function button 'Folded package'.
2
Select 'Length'.
3
Enter a range between 276 - 310 mm in steps of 1 mm; default 210 mm
4
Set the binding edge
Press the 'Finishing' card in the 'Print' section.
1
Press the function button 'Binding'.
2
Select binding enabled or disabled.
3
If you selected enabled enter a range between 15 - 30 mm in steps of 1 mm;
4
default 20 mm.
Set the reinforcement
Press the 'Finishing' card in the 'Print' section.
1
Press the function button 'Binding'.
2
Select 'Reinforce' enabled or disabled.
3
You can overrule the standard folding program with settings from the printer
driver or the scanner operating panel.
See 'Standard folding settings' on page 290 for complete information about
defining default folding settings.
The folder 291