Table of Contents
Advertisement
Figure 2-1c
CUB
CADET
REMOVE
EXISTING
HARDWARE
Rotating The Donaldson Air Cleaner
Note: If equipped with a Donaldson air cleaner, unit
must be rotated to make clearance for top main frame
assembly. To rotate Donaldson air cleaner, loosen bolt
on air cleaner bracket, rotate air cleaner forward as
needed for clearance as shown in Figure 2-1d and
tighten.
Figure 2-1d
FORWARD POSITION
LOOSEN BOLT
2-2 Left And Right Lower Mount Plate
Installation
Fasten the left lower mount plate P#(B0395) and the
right lower mount plate P#(B0396) to the rear frame of
the mower using the (2) existing bolts and (2) nuts
removed from the rear panel guard and (2) 1/2"-13 x 1"
HHCS P#(K1231) and (2) 1/2"-13 flange nuts
P#(K1246). See Figure 2-2a and 2-2b.
LESCO
ROTATE TO THE
Figure 2-2a
RIGHT LOWER
MOUNT PLATE
Figure 2-2b
EXISTING
HARDWARE
2-3 Main Frame Assembly Installation
Lift the main frame assembly P#(A0845) into position on
top of the left and right lower mount plate. Fasten using
(2) 3/8"-16 x 1" HHCS and (2) 3/8"-16 flange nuts PER
SIDE. See Figure 2-3.
Figure 2-3
LOWER
MOUNT
PLATE
6
1/2"-13 x 1" HHCS
1/2"-13 FLANGE NUT
EXISTING
HARDWARE
1/2"-13 x 1" HHCS
1/2"-13 FLANGE NUT
LEFT LOWER
MOUNT PLATE
MAIN
FASTEN
FRAME LEG
HERE
Advertisement
Table of Contents
