Rotating The Donaldson Air Cleaner
Note: If equipped with a Donaldson air cleaner, unit
must be rotated to make clearance for top main frame
assembly.
To rotate Donaldson air cleaner, loosen bolt on air
cleaner bracket, rotate air cleaner forward as needed for
clearance as shown in Figure 2-1c. and tighten.
Figure 2-1c.
Removing The Rear Panel Guard
Remove the two existing nuts and bolts that fasten the
panel guard to the rear frame of the mower. See Figure
2-1d. and 2-1e. for reference.
Figure 2-1d.
CUB CADET MODEL
LESCO MODEL
Rotate To The
Forward Position
Loosen Bolt
Rear Panel Guard
Rear Panel Guard
9 6
CUB
Figure 2-1e.
CADET
Remove Existing
Hardware
2-2 Lower Mount Plate And PTO
Mount Plate Assembly Installation
Fasten the lower mount plate P#(B0395) and the PTO
mount plate assembly P#(A0846) to the rear frame of
the mower using the (2) existing bolts and (2) nuts
removed from the rear panel guard and (2) 1/2"-13 x 1"
HHCS P#(K1231) and (2) 1/2"-13 flange nuts
P#(K1246). See Figure 2-2a. and 2-2b.
Figure 2-2a.
Figure 2-2b.
(1) 1/2"-13 x 1" HHCS
(1) 1/2"-13 Flange Nut
Existing
Hardware
LESCO
(1) 1/2"-13 x 1" HHCS
(1) 1/2"-13 Flange Nut
Existing
Hardware
PTO Mount
Plate Assembly
Lower
Mount Plate