Table of Contents
Advertisement
2-4 Exhaust Deflector Installation
Fasten the exhaust deflector P#(C0058) to the underside
of the right lower mount plate P#(B0396) and fasten
using (2) 1/4"-20 x 3/4" HHCS and (2) 1/4"-20 nyloc nuts.
See Figure 2-4.
Figure 2-4
EXHAUST
DEFLECTOR
2-5 Outer Engine Mount Tube
Installation
Fasten the outer engine mount tube P#(A0977) to the
rear frame of the mower. Use (2) 1/2"-13 x 1" HHCS
P#(K1231) and (2) 1/2"-13 flange nuts P#(K1246). You
will use the existing holes from which the weights were
removed. See Figure 2-5 for reference.
Figure 2-5
REAR FRAME
RIGHT LOWER
MOUNT PLATE
(2) 1/4"-20 x 3/4" HHCS
(2) 1/4"-20 NYLOC NUT
(2) 1/2"-13 x 1" HHCS
(2) 1/2"-13 FLANGE NUTS
OUTER ENGINE
MOUNT TUBE
2-6 Engine Mount Arm Assembly
Installation
Insert the engine mount arm assembly P#(A0976) into
the outer engine mount tube P#(A0977) and fasten with
(1) detent pin P#(J0248). See Figure 2-6.
Figure 2-6
OUTER ENGINE
MOUNT TUBE
DETENT
PIN
2-7 Engine/Blower/Blade Assembly
Installation
Place the engine/blower/blade assembly onto the engine
mount arm assembly and align the mounting holes.
Fasten by using (4) 5/16"-18 x 1-1/2" HHCS P#(K1157)
and (4) 5-16"-18 flange nuts P#(K1178). See the figures
below for detail.
Figure 2-7a
ENGINE/BLOWER
BLADE ASSEMBLY
Figure 2-7b
(4) 5/16"-18 x 1-1/2" HHCS
(4) 5/16"-18 FLANGE NUT
7
9
ENGINE MOUNT
ARM ASSEMBLY
ENGINE MOUNT
ARM ASSEMBLY
Advertisement
Table of Contents
