Introduction And Description; Introduction; Description; Installation For Use - Peco 21621209 Operator's Manual

INTRODUCTION AND DESCRIPTION

1-1 Introduction

We are pleased to have you as a PECO customer. Your
collection system has been designed to give you a low
maintenance, simple, and effective way to collect the
grass clippings from your mower. This manual is
provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
NOTE: all references made to right, left, front, rear, top
or bottom are as viewed from the normal operator's
position on the mower.

1-2 Description

The collection system is designed for turf maintenance
where there is a need to collect the grass clippings as
the mower cuts the turf. It is also good for picking up
leaves and twigs in pre-season and post-season clean-
up.
The engine/blower/blade assembly, is mounted on the
right side of the unit. The blower draws grass clippings
from the discharge area of the cutter deck up to the
aluminum container mounted over the rear portion of the
frame. The operator can engage the engine/blower/blade
assembly by starting the engine.
Once the container is full of clippings, the operator can
easily push and raise the lift handle, releasing the
container's rear door and the container will pivot towards
the ground.
Section II

INSTALLATION FOR USE

2-1 Preparation Of Mower

Carefully dismantle wooden shipping crate from around
the components. Cut retaining straps and separate the
parts. The collection system will have various parts
located inside. Remove and sort all parts for easy
identification.
NOTE: Before each step of assembly it will help to study
the exploded drawings on pages 9 through 16.
From the underside of the engine remove the bolt and
bushing from the electric clutch assembly. It will help to
use a bungee cord or similar device to hold the electric
clutch in place during this step.
SECTION I
Removing The Weight Kit
Remove the two carriage bolts and flange nuts that
fasten the two existing weight bars to the rear frame of
the mower. Remove the weight bars. See Figure 2-1a.
Figure 2-1a
REMOVE
WEIGHT BARS
Removing The Rear Panel Guard
Remove the two existing nuts and bolts that fasten the
panel guard to the rear frame of the mower. See Figure
2-1b and 2-1c for reference.
Figure 2-1b
REMOVE
REMOVE
5
REMOVE CARRIAGE
BOLTS AND FLANGE NUTS
CUB CADET MODEL
LESCO MODEL