Table of Contents
Advertisement
2-17 Lower Hose To Boot Installation
Take the unattached end of the lower hose and slide it
over the circular end of the boot. Use the lower hose
clamp to secure the hose to the boot (Figure 2-17). Tip:
Before securing clamp rotate hose counter-clockwise
(away from yourself) approximately 1" to add in retaining
boot to mower deck.
Figure 2-17
LOWER
HOSE
CLAMP
2-18 Front Weight Installation
The front weight kit assemblies are different for the Cub
Cadet and Lesco models. Cub Cadet models use a
weight bar from the manufacturer. The Lesco models
use the weights that are provided with the mower.
CUB CADET
LESCO
BOOT
7"- 8"
CUB CADET
Fasten the weight brackets P#(B0026) to the weight
P#(B2220) using (2) 1/2"-13 u-bolts P#(K0331) and (4)
1/2"-13 flange nuts P#(K1246). It is recommended that
you have someone help you lift the weight on the wheel
frame. Fasten the weight to the wheel frame using (2)
3/8"-16 u-bolts P#(K1119) and (4) 3/8"-16 flange nuts
P#(K1215). See Figure 2-18a. for reference.
Figure 2-18a
1/2"-13
U-BOLT
WEIGHT
WEIGHT
BRACKET
Fasten the (2) weight brackets P#(B3750) to the wheel
frame using (1) 3/8"-16 x 2-1/2"-3" u-bolts P#(K1432)
and (2) 3/8"-16 flange nuts P#(K1215) PER SIDE.
Fasten the weights that were removed in section 2-1, to
the weight brackets, using (1) 3-8"-16 x 4" HHCS
P#(K1201) and (1) 3/8"-16 flange nuts P#(K1215) PER
SIDE. See Figure 2-18b. for reference.
Figure 2-18b
(1) 3/8"-16 x 2-1/2" x 3" U-BOLT
(2) 3/8"-16 FLANGE NUTS (PER SIDE)
.
17
9
3/8"-16
U-BOLT
LESCO
WEIGHTS
WEIGHT
BRACKETS
Advertisement
Table of Contents
