Panasonic KX-TDA15 Features Manual page 343

→ 3.15.2 [9-2] Network Data Transmission—Network BLF Data Transmission for Centralised Operator
Feature—Data Transmission Counter
• If it is not possible to remotely turn off transmission of extension status information using the NDSS
Monitor Release feature because of network conditions, it is possible to perform the same operation
directly through system programming at the monitored PBX.
→ 3.10.8 [4-1-6] Wired Extension—NDSS Link Data - Send
→ 3.10.15 [4-2-4] Portable Station—NDSS Link Data - Send
• When using a private IP network, if extension status information is lost by the network, in some cases
an NDSS button may not be able to display the status of the relevant extension.
• NDSS can not be used when two PBXs are networked using the [TIE Line Call by Own PBX
Extension Number] feature (→ 1.26.1 TIE Line Service).
Programming Manual References
PC Programming Manual
3.7.14 [1-1] Slot—BRI Port—ISDN CO—Networking Data Transfer
3.8.11 [2-7-1] Class of Service—COS Settings—Extension Feature—Manager
3.10.5 [4-1-4] Wired Extension—Flexible Button
→ Type
→ Dial (for NDSS)
3.10.8 [4-1-6] Wired Extension—NDSS Link Data - Send
3.10.13 [4-2-3] Portable Station—Flexible Button
→ Type
→ Dial (for NDSS)
3.10.15 [4-2-4] Portable Station—NDSS Link Data - Send
3.10.17 [4-3] DSS Console—Flexible Button
→ Type
→ Dial (for NDSS)
3.15.2 [9-2] Network Data Transmission
3.15.3 [9-3] Network Operator (VoIP)
3.15.4 [9-4] NDSS Key Table
PT Programming Manual
[511] Manager Assignment
Feature Guide References
1.26.1 TIE Line Service
1.26.2 Voice over Internet Protocol (VoIP) Network
1.26.4 QSIG Standard Features
User Manual References
1.2.1 Basic Calling
2.1.6 Releasing Network Direct Station Selection (NDSS) Monitor
1.26 Networking Features
Feature Guide 343