Pause Insertion - Panasonic KX-TDA15 Features Manual

1.5 Making Call Features
1.5.4.6

Pause Insertion

Description
Pressing a PAUSE button inserts a preprogrammed Pause time between digits of a user-dialled number
before the number is dialled out, allowing certain numbers separated with a pause to be used to access
certain features (e.g., access codes, seizing idles lines, etc.).
When a pause is needed, pauses must be inserted manually (pressing the PAUSE button) in all cases,
except for the following access codes where a pause is automatically inserted between the user-dialled
access code and the subsequent digits:
a)
Host PBX Access code (→ 1.5.4.7 Host PBX Access Code (Access Code to the Telephone
Company from a Host PBX))
b)
Special Carrier Access code (→ 1.5.4.8 Special Carrier Access Code)
c)
Second Dial Tone Waiting code
Conditions
• The Pause time is programmable for each trunk.
• Pauses can be stored in Memory Dialling.
• When a Second Dial Tone Waiting code is dialled after seizing a trunk, a preprogrammed number of
pauses are inserted after the code.
• ARS
A pause is not automatically inserted between the user-dialled access code and the subsequent digits
when the ARS mode is enabled. (1.9.1 Automatic Route Selection (ARS))
Programming Manual References
PC Programming Manual
3.7.11 [1-1] Slot—LCO Port—Pause Time
3.7.31 [1-1] Slot—DID Port—Pause Time
3.8.4 [2-3] Timers & Counters—Miscellaneous—During Conversation—Pause Signal Time
3.12.4 [6-4] Second Dial Tone
PT Programming Manual
[416] LCOT Pause Time
94 Feature Guide