Panasonic KX-TDA15 Features Manual page 278

1.22 Administrative Information Features
Number in
the Pattern
(3)
(4)
(5)
278 Feature Guide
Item
Ext (Extension) Shows the extension number, floating extension number, etc.,
which was engaged in the call.
Also shows the following codes:
Dxxx: Outgoing trunk call from a doorphone (xxx=doorphone
number) (→ 1.15.1 Doorphone Call)
Txxx: Outgoing trunk call by TIE line service (xxx=trunk group
number)
*xxx: Verified call (xxx=verification code) (→ 1.8.6 Verification
Code Entry)
CO (Trunk) Shows the trunk number used for the call.
For patterns A and B, "00" will be shown for trunk numbers over
hundred.
Dial Number [Trunk Call]
Outgoing Trunk Call
Shows the dialled telephone number.
Valid digits are as follows:
0 through 9,
P: Pause
F: EFA signal
=: A Host PBX Access code (→ 1.5.4.7 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialling
X: Privacy dial
–: Transferred call
If the transfer destination extension enters some digits, the entered
digits will be added after "–".
Incoming Trunk Call
Shows <I> + the caller's identification name/number.
It is also possible to show the DDI/DID/MSN call information. In this
case, <D> + DDI/DID/MSN name/number is added before <I> .
[Outgoing Intercom Call]
Shows the dialled extension number followed by "EXT".
[Log-in/Log-out]
Shows the log-in or log-out status.
[Check-in/Check-out]
Shows the check-in or check-out status. (→ 1.23.2 Room Status
Control)
[Timed Reminder]
Shows the status of a timed reminder, either "Start", "No Answer",
or "Answer". (→ 1.24.4 Timed Reminder)
[Printing Message]
Shows the selected message. (→ 1.22.2 Printing Message)
[Sensor Call]
Shows calls from an external sensor as follows:
<I> S + sensor number. (→ 1.15.9 External Sensor)
Description
, #