Hilti WSC 70-A36 Operating Instructions Manual page 23

2.3 Grips
Grip and auxiliary grip
2.4 Protective device
Blade guard and pivoting guard
2.5 Lubrication
en
Grease lubrication
2.6 Deep discharge protection
To extend the life of the battery and the motor, the electronic control system is designed to audibly reduce blade
drive speed when excessive pressure is applied, up to the point at which the blade stalls completely when pressure is
maintained causing activation of the power cut-out.
CAUTION
So long as the on/off switch remains depressed, the power tool runs up to speed again when the pressure applied to
it is released, just like a mains-powered tool.
2.7 Li‑ion battery charge status
When a Li-ion battery is used, the charge status can be indicated by gently pressing one of the battery release buttons
(press until resistance is felt - do not release the battery). The display on the rear of the battery provides the following
information:
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
2.8 Items supplied as standard
1 Power tool
1 Saw blade
1 Hexagon socket wrench
1 Operating instructions
1 Hilti toolbox (optional)
1 Cardboard box (optional)
2.9 Additional items required for operating the tool
For WSC 70‑A36, one B 36/2.4 NiCd battery or B 36⁄3.3 or B 36⁄3.9 Li‑Ion battery and C4⁄36‑90 or C4⁄36‑350 or
C7/36‑ACS or C4/36‑ACS battery charger.
NOTE
Depending on the version, these items may be supplied with the power tool.
18
LEDs blink
-
-
-
-
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %