Table of Contents
Advertisement
5.
Remove the power connector (5).
Reverse this procedure to install the power connector cable and bracket.
USB board
Description
USB board (includes USB port)
NOTE:
The USB board does not include the USB board cable. The USB board cable is included in the
Cable Kit, spare part number 742103-001. See
information.
Before removing the USB board, follow these steps:
1.
Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are off
or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.
Disconnect the power from the tablet and keyboard base by unplugging the power cord from the tablet
and keyboard base.
3.
Disconnect the tablet from the keyboard base.
4.
Remove the bottom cover (see
a.
I/O board (see
b.
TouchPad (see
c.
Keyboard base battery (see
d.
Power connector cable and bracket (see
Remove the USB board:
1.
Detach the USB board cable (1) from the keyboard base. (The USB board cable is attached to the
keyboard base with double-sided adhesive.)
2.
Disconnect the hinge assembly cable (2) from the USB board.
Cable Kit on page 21
Bottom cover on page
I/O board on page
66)
TouchPad on page
68)
Keyboard base battery on page
for more Cable Kit spare part
65), and then remove the following components:
69)
Power connector cable on page
Removal and replacement procedures
Spare part number
742106-001
70)
71
Advertisement
Table of Contents
