Table of Contents
Advertisement
Description
For use only on computer models not equipped with WWAN capability (includes micro SD Card Reader
slot)
NOTE:
The card reader board does not include the card reader board cable. The card reader board cable is included in the Cable Kit,
spare part number 742103-001. See
Before removing the card reader board, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Remove the tablet battery (see
Remove the card reader board:
1.
Release the system board ZIF connector (1) to which the card reader board cable is attached, and then
disconnect the card reader board cable from the system board.
2.
Remove the two Phillips PM2.0×3.0 screws (2) that secure the card reader board to the
display assembly.
3.
Remove the card reader board (3) by sliding it forward, making sure to carefully route the card reader
board cable through the opening (4) in the display assembly.
58
Chapter 5 Removal and replacement preliminary requirements
Cable Kit on page 21
for more Cable Kit spare part information.
Back cover on page
36).
Tablet battery on page
37).
Spare part number
736891-001
Advertisement
Table of Contents
