Touchscreen Board; Nfc Module - HP Spectre 13x2 Pro Maintenance And Service Manual

TouchScreen board

NOTE: The TouchScreen board is included with the display panel assembly spare part kit, spare part
numbers 737696-001 (13.3-inch, AG, FHD, WLED TouchScreen, display panel assembly) and 737697-001
(13.3-inch, AG, HD, WLED TouchScreen, display assembly).
NOTE: The TouchScreen board does not include the TouchScreen board cable. The TouchScreen board cable
is included in the Cable Kit, spare part number 742103-001. See
part information.
Before removing the TouchScreen board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Remove the tablet battery (see
Remove the TouchScreen board:
1. Release the two TouchScreen board ZIF connectors (1) and (2) to which the display panel TouchScreen
cables are attached, and then disconnect the display panel TouchScreen cables from the TouchScreen
board.
2. Release the system board ZIF connector (3) to which the TouchScreen board cable is attached, and then
disconnect the TouchScreen board cable from the system board.
3. Detach the TouchScreen board (4) from the display assembly. (The TouchScreen board is attached to
the display assembly with double-sided adhesive.)
4. Remove the TouchScreen board and cable.
Reverse this procedure to install the TouchScreen board.

NFC module

Description
NFC module (includes double-sided adhesive)
Back cover on page 36).
Tablet battery on page
Cable Kit on page 21
37).
Removal and replacement procedures
for more Cable Kit spare
Spare part number
736886-001
51