Table of Contents
Advertisement
3.
Remove the keyboard base battery (3) by sliding it up and away at an angle.
Reverse this procedure to install the keyboard base battery.
Power connector cable
Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1.
Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are off
or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.
Disconnect the power from the tablet and keyboard base by unplugging the power cord from the tablet
and keyboard base.
3.
Disconnect the tablet from the keyboard base.
4.
Remove the bottom cover (see
Remove the power connector cable:
1.
Disconnect the power connector cable (1) from the USB board.
2.
Release the power connector cable from the retaining clip (2) built into the keyboard shield.
3.
Remove the two Phillips PM2.0×3.25 screws (3) that secure the power connector and bracket to the
keyboard base.
4.
Remove the power connector bracket (4).
70
Chapter 5 Removal and replacement preliminary requirements
Bottom cover on page
65).
Spare part number
742104-001
Advertisement
Table of Contents
