Usb Board - HP 245 G6 Maintenance And Service Manual

USB board

Description
USB board
USB board cable
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the speakers (see
To remove the USB board:
1. Disconnect the cable from the connector on the USB board (1).
2. Remove the Phillips PM2.5×5.0 screw (2) that secures the board to the computer.
3. Remove the USB board from the computer (3).
Reverse this procedure to install the USB board.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 28).
Optical drive on page
Bottom cover on page
Speakers on page 50).
29), if installed.
35).
Spare part number
925450-001
925343-001