Table of Contents
Advertisement
4.
Remove the Phillips M2.0 × 3.0 screw (3), and then remove the WLAN module (4).
NOTE:
with the appropriate connector on the module.
5.
If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a
protective sleeve on the antenna connector, as shown in the following illustration.
To install a WLAN module, reverse this procedure.
USB/audio board
To remove the USB/audio board, use this procedure and illustration.
Table 5-4
USB/audio board description and part number
Description
USB/audio board
USB/audio board cable (available in the Cable Kit)
Before removing the USB/audio board, follow these steps:
1.
Prepare the computer for disassembly (see
When connecting the antenna cables, be sure to match the number or letter on the cable
Preparation for disassembly on page
Spare part number
N69081-001
N59283-001
29).
USB/audio board
33
Advertisement
Table of Contents
