Table of Contents
Advertisement
Before removing the proximity sensor module, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Remove the tablet battery (see
Remove the proximity sensor module:
1.
Disconnect the proximity sensor module cable (1) from the system board.
2.
Remove the Phillips PM2.0×3.0 screw (2) that secures the proximity sensor module to the display
assembly.
3.
Remove the proximity sensor module (3) and cable.
Reverse this procedure to install the proximity sensor module.
Webcamera/microphone module
Description
Webcamera/microphone module (includes double-sided adhesive and grounding tape)
NOTE:
The webcamera/microphone module does not include the webcamera/microphone module cable. The webcamera/
microphone module cable is included in the Cable Kit, spare part number 742103-001. See
spare part information.
Back cover on page
36).
Tablet battery on page
37).
Cable Kit on page 21
Removal and replacement procedures
Spare part number
736900-001
for more Cable Kit
39
Advertisement
Table of Contents
