Table of Contents
Advertisement
Power/USB board
Table 6-4
Spare part description and number
Description
Power/USB board
Power/USB board cable (included in Cable Kit)
Before removing the power/USB board, follow these steps:
1.
Prepare the computer for disassembly
2.
Place the computer in "Battery Safe mode"
3.
Remove the bottom cover
4.
Remove the battery
Remove the power/USB board:
1.
Disconnect the cable from the ZIF connector on the power/USB board (1).
2.
Remove the two Phillips M2.0×4.0 screws (2) that secure the board to the computer.
3.
Lift the rear of the board up, and then pull the board away from the connector and out of the computer
to remove it (3).
Reverse this procedure to install the power/USB board.
(Preparation for disassembly on page
(Battery Safe mode on page
(Bottom cover on page
(Battery on page
32).
30).
31).
Component replacement procedures
Spare part number
L44536-001
L44509-001
30).
47
Advertisement
Table of Contents
