Micro Solid-State Drive (Mssd) - HP Spectre 13x2 Pro Maintenance And Service Manual

micro Solid-state drive (mSSD)

Description
256-GB mSATA-3 mSSD
128-GB mSSD
Before removing the solid-state drive, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Remove the tablet battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the system board. (The
solid-state drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Back cover on page 36).
Tablet battery on page 37).
Removal and replacement procedures
Spare part number
749037-001
737218-001
41