•
Single phase 200-240 V
•
Side access to optical adjustments
•
4K resolution for flexibility and future proofing
•
Omnidirectional operation
•
TruLife electronics
•
New LCD display to provide information at-a-glance
How the projector works
The Boxer 4K30 accepts a variety of input signals for projection on front or rear projection screens,
typical in commercial or other large screen applications.
High-brightness light is generated by six mercury vapor lamps, then modulated by three Digital
Micromirror Device (DMD) panels responding to incoming data streams of digitized red, green and blue
color information. As these digital streams flow from the source, light from the responding "on" pixels
of each panel is reflected, converged and then projected to the screen through one or more projection
lenses, where all pixel reflections are superimposed in sharp full-color images.
List of components
Verify all components were received with the projector.
•
Power cord for full brightness, six lamp operation
•
Power cord for limited power, single lamp operation
•
IR remote keypad
Site requirements
To safely install and operate the projector, the installation location must have restricted access for
authorized personnel only and meet these minimum requirements.
Physical operating environment
Provides specifications for the operating environment.
•
Ambient temperature (operating) 5 to 40°C (41 to 104°F) up to 1500 ft
•
Humidity (non-condensing) 10 to 80%
•
Operating altitude: 10,000 ft maximum at 5 to 25 degrees Celsius ambient
Power connection
The projector uses an innovative dual AC inlet power system that offers two power modes.
To operate at full brightness (six lamps), power the projector using AC Input 1 if the appropriate high
power source is available. To operate in limited power mode (single lamp), power the projector using
standard lower power sources using AC Input 2. A different power cord is provided for each power
Boxer 4K30 User Manual
020-101777-03 Rev. 1 (11-2015)
Introduction
10