Connecting A Network Management Station To The Switch - Nortel 8003AC Installation Manual

88 Installing Metro Ethernet Routing Switch 8600 modules and connecting equipment
Setting
Synchronous/asynchronous
mode
Auto answer
Local character echo
Supervisory functions
Baud rate
Data bits
Stop bits
Parity

Connecting a network management station to the switch

Connect a network management station to the management port for
out-of-band management of the switch.
The management port on the CPU modules is a 10/100 Mb/s Ethernet port
implemented on an RJ-45 connector wired as an MDI connection. You
can use this port to connect the switch to a network management station
for out-of-band management of the switch using a Web browser or Device
Manager.
The port has its own IP address but does not switch traffic to other ports in
the chassis.
Prerequisites
•
Procedure steps
Step
1
Copyright © 2005-2007, Nortel Networks
.
To connect ports that will operate at 100 Mb/s, use only Category 5 UTP
cable. For 10 Mb/s connections, you can use Category 3, 4, or 5 copper
unshielded twisted pair (UTP) cable.
Action
Insert the UTP cable into the RJ-45 receptacle connector on the
CPU module.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
Value
Asynchronous
Answer on two rings when DTR is active.
Off
Off
9600
8
1
None
—End—