Table of Contents
Advertisement
5
6
7
8
Copyright © 2005-2007, Nortel Networks
.
P1 connector header, pins 5 and 6
Align the jumper contacts with pins 5 and 6 of the P1 connector
header.
Slide the jumper onto pins 5 and 6 until the jumper meets the
connector header (see
(page
141)).
P1 connector header with jumper installed
Replace the ESM 8668 into the chassis (see
a module" (page
75)).
Enable the slot to activate the ESM 8668 using the CLI command.
Specify the number of the slot where the ESM 8668 is installed for
<slot-number>.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
Installing the jumper on an ESM 8668 141
"P1 connector header with jumper installed"
"Installing and replacing
Advertisement
Table of Contents
