Nortel 8003AC Installation Manual page 31

8608SXE module LEDs
Type
Port
Module
The 8608SXE module supports up to 32 000 table entries in its forwarding
engine. For information about table entry characteristics, see Network
Design Guidelines (313197-E).
The Metro Ethernet Routing Switch 8600 system has three hardware
operating modes:
•
•
•
The 8608SXE module does not support R or M mode.
Copyright © 2005-2007, Nortel Networks
.
Label Color/State
TX Green/Blinking
Amber/Steady
Off
RX Green/Steady
Green/Blinking
Amber/Steady
Off
Online Green/Steady
Amber/Steady
Off
Default mode (32 000 table entries) supports up to 32 000 hardware
records. This mode supports all modules.
M mode (128 000 table entries) supports up to 128 000 hardware
records. This mode supports M modules only.
R mode supports up to:
— 256 000 IP routes
— 64 000 MAC entries
— 32 000 ARP entries
This mode supports R modules only.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
8608SXE module 31
Meaning
The port is transmitting data.
A fault condition exists on the line or on
the attached remote device.
The port did not detect a fault condition.
The port has established a link and is
enabled.
The port is receiving data.
The port has either no optical signal or
no link synchronization.
The port has signal but no link.
The module has completed its power-on
self-test and software initialization and
is operating normally.
The module failed its power-on self-test.
The switch power is off. If the switch
power is on, the module is going
through its power-on self-test and
software initialization. A module in this
state is not yet functional.