Table of Contents
Advertisement
132 Appendix A Metro Ethernet Routing Switch 8600 module technical specifications
Connector types
Ethernet Management port:
RJ-45 connector wired as MDI (see
Console port:
DB-9 connector (see
"Pin assignments: 8692omSF module Console port" (page
Modem port:
DB-9 connector (see
"Pin assignments: DTE to DCE" (page
Cable specifications
Ethernet Management port:
Category 3, 4, or 5 UTP cable (10 Mb/s operation)
Category 5 UTP cable (100 Mb/s operation)
Console port:
RS-232 cable
Modem port:
DTE-to-DCE cable (straight or transmit cable)
Management port
The Management port is a 10/100 Mb/s Ethernet port implemented on an
RJ-45 connector wired as an MDI connection.
"Pin assignments: 8692omSF module" (page 132)
assignments for this connector.
Pin assignments: 8692omSF module
Connector
Console serial port
The Console serial port is implemented as a DB-9 connector. This port
can operate as a data terminal equipment (DTE) or data communication
equipment (DCE) device. Use the switch to the left of the port to set the port
to DTE (right) or DCE (left). Default settings for this port are 9600 bits/s, 8
data bits, no parity, and one stop bit.
Copyright © 2005-2007, Nortel Networks
.
"Pin assignments: 8692omSF module" (page
Pin number
1
2
3
6
4, 5, 7, 8
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
133))
shows the pin
Signal
Output transmit data + (TX+)
Output transmit data - (TX-)
Input receive data + (RX+)
Input receive data - (RX-)
Not used
132))
133))
Advertisement
Table of Contents
