Table of Contents
Advertisement
5
6
7
8
9
Configuring a system for individual accounts
Use this procedure to configure an individual account.
Prerequisites
•
•
Copyright © 2007-2008 Nortel Networks
.
Reply Y to accept the account method confirmation.
OR
Reply N to go back to the User Accounts screen and change
selections.
Once the account method is confirmed, the installer displays the
prompt to create the passwords. The password limitations and
requirements appear on-screen.
If you selected the option to use a shared password, the installer
prompts you to create the shared password.
If you selected the option to configure a password for each
preconfigured account, the installer prompts you to create a
password for each preconfigured account.
Create the user account passwords as prompted by the
installer. Ensure the passwords meet the requirements
displayed on-screen. The passwords must be entered again for
confirmation.
The installer displays the system accounts configuration screen.
Create passwords for each system account as prompted by the
installer.
The installer displays the following message:
System Configuration Complete
Press Enter to continue.
The installer applies the system configurations. This may take
several minutes.
After the configuration has been applied, the server reboots.
Login access is available at the physical server, through RSA-II
remote control (if configured), and available SSH.
If applicable, install platform patches.
You have completed the steps described in
Syslog, and Audit Daemon settings" (page
For more information about installing Linux Maintenance Releases, see
"Applying the Linux Maintenance Release " (page
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Configuring accounts and passwords 53
--End--
"Configuring the NTP,
47).
92).
Advertisement
Table of Contents
