Table of Contents
Advertisement
108 Maintenance Releases
Procedure Steps
Step
1
2
3
4
5
6
7
8
9
Copyright © 2007-2008 Nortel Networks
.
Action
Load the ServeRAID firmware upgrade CD into the CD-ROM
drive.
Log on to the server as the SSA role (ntsysadm).
Reboot the server.
If the operating system has been installed, change the boot
sequence so that the CD-ROM is the primary boot device by
doing the following:
•
When the BIOS information appears, press F12 to select the
boot sequence.
•
Select CD-ROM as the primary boot device.
Otherwise, wait for the server to reboot.
The ServeRAID Manager screen appears. (This may take up to
two minutes.)
If an upgrade is not required, click OK to reboot server and
go to step 9. (The OK prompt does not always display. If this
happens, select File> Exit, and select Restart to reboot the
server.)
Otherwise, select Update to apply the update.
Attention: Do not power off the system during the update.
The ROM Update Wizard displays a firmware message.
Click OK.
Click Next to complete the update.
Click Finish.
The server reboots.
Remove the CD from the CD-ROM drive.
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
--End--
Advertisement
Table of Contents
